Clear Linkflap Action; Set Linkflap Threshold - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Defaults
None.
Mode
Switch mode, read‐write.
Example
This example shows how to set the link flap violation action on port ge.1.4 to generating a Syslog
entry.
C2(rw)->set linkflap action

clear linkflap action

Use this command to clear reactions to a link flap violation.
Syntax
clear linkflap action [port-string] {disableInterface | gensyslogentry | gentrap
| all}
Parameters
port‐string
disableInterface
gensyslogentry
gentrap
all
Defaults
If port‐string is not specified, actions will be cleared on all ports.
Mode
Switch mode, read‐write.
Example
This example shows how to clear the link flap violation action on port ge.1.4 to generating a
Syslog entry.
C2(rw)->clear linkflap action

set linkflap threshold

Use this command to set the link flap action trigger count.
Syntax
set linkflap threshold port-string threshold-value
ge.
1.4 gensyslogentry
(Optional) Specifies the port(s) on which to clear the link flap action.
Clears the reaction as disabling the interface.
Clears the reaction as generating a syslog entry.
Clears the reaction as generating an SNMP trap.
Clears the reaction as all of the above.
ge.
1.4 gensyslogentry
clear linkflap action
SecureStack C2 Configuration Guide 7-27