Setting item
Judgement target
●
Judgement
●
[Not selected]
●
Number of labels
●
Area
●
Gravity X
●
Gravity Y
●
Elliptic axis angle
●
Elliptic major axis
●
Elliptic minor axis
●
Elliptic ratio
●
Rectangle width
●
Rectangle height
●
Rectangle X1
●
Rectangle Y1
●
Perimeter
●
Circularity
●
Fit rect major axis
●
Fit rect minor axis
●
Fit rect ratio
●
Inscribed circle X
●
Inscribed circle Y
●
Inscribed circle R
●
Circum. circle X
●
Circum. circle Y
●
Circum. circle R
●
Number of holes
●
Display radio buttons
Output Parameters (Labeling+)
Specify how to treat the coordinates to be output to the external device as measurement results.This
item can be changed if necessary.Normally, the factory default value will be used.
Important
After setting up the measurement parameters, changing the output parameters will cause measurement results
●
to vary accordingly.If the output parameters have been changed, re-specify the measurement, too.
1.
Tap [Output parameter] in the Item Tab area.
FZ3 Processing Items List Manual
Set value
[Factory default]
Specify the labels to be
targeted.
When "Selected label" is
selected, only labels
specified by number are
All labels
judged.(However, when
●
[Selected label]
Judgement condition is
●
Number of labels, it is not
applied.)
When "All labels" is selected,
all extracted labels are
judged.
Set up the judgement
0.000 to
condition.
9999999.999
Specify the feature quantities
[Judgement 0]
displayed on the image.
Description
Labeling+
205
2