Output Parameters (Edge Pitch) - Omron XPECTIA FZ3 User Manual

Set value
Setting item [factory
default]
0 to 442
Noise level
[5]
0 to 9999
Noise width
[0]
4.
When the setting has been changed, tap [Measurement] in the Detail area to verify whether
measurements can be made correctly.
5.
Set up the judgement condition.
Setting item
Edges
Pitch
Ave pitch
Width
Average width

Output Parameters (Edge Pitch)

Specify how to treat the coordinates to be output to the external device as measurement results.This
item can be changed if necessary.Normally, the factory default value will be used.
Important
After setting up the measurement parameters, changing the output parameters will cause measurement results
●
to vary accordingly.If the output parameters have been changed, re-specify the measurement, too.
1.
Tap [Output parameter] in the Item Tab area.
FZ3 Processing Items List Manual
When detection is affected by noise, increase this value.
Reference: See "User's Manual", "Noise level" (p.305)
Set the width for judging noise.
When detection is affected by noise, increase this value.
Reference: See "User's Manual", "Noise width" (p.306)
Set value
0 to 999
0 to 99999.9999
0 to 99999.9999
0 to 99999.9999
0 to 99999.9999
Description
Description
Specify a range to be
judged as OK.
Edge Pitch
2
129