Region Setting (Scan Edge Position) - Omron XPECTIA FZ3 User Manual

Item List for Scan Edge Position
Item name
Region This item is used to set up the measurement area.
setting Reference:
Edge color
If the color of the edges to be detected is decided, specify the information for the edge color to be
(for color
detected.
cameras
Reference:
only)
This item can be changed if necessary.
Ref. position The edge position measured once is registered when the region is set.
Reference:
This item changes the measurement parameter as necessary when the measurement result is
unstable.
Measurement The displayed items depend on whether your camera is a color or monochrome camera.Normally,
the factory default value will be used.
Reference:
This item specifies the judgement condition for measurement results.
Judgement
Reference:
This item can be changed if necessary.Normally, the factory default value may be used.
Output
Select the measurement result coordinates and set how to handle the coordinates.
parameter
Reference:

Region Setting (Scan Edge Position)

This item is used to set up the measurement area.
Specify the measurement region for [Scan Edge Position] by using wide straight lines.
1.
In the Item Tab area, tap [Region setting].
FZ3 Processing Items List Manual
Region Setting (Scan Edge Position) (p.133)
Edge Color Specification - For Color Cameras Only (Scan Edge Position) (p.135)
Reference Position (Scan Edge Position) (p.136)
Measurement Parameters (Scan Edge Position) (p.137)
Judgment Conditions (Scan Edge Position) (p.140)
Output Parameters (Scan Edge Position) (p.142)
Description
Scan Edge Position
2
133