Settings Flow (Shape Search+); Model Registration (Shape Search+) - Omron XPECTIA FZ3 User Manual

Settings Flow (Shape Search+)

Set up shape search+ according to the following steps.
List of Shape Search+ Items
Item name
This item registers the pattern characteristic of the measurement image as a model.
Model Model parameter values can be changed as needed to address unstable measurement results or to
register increase the processing speed.Normally, the factory default value will be used.
Reference:
This item is used to set up the measurement area.
Region
Restricting the range enables accurate measurement in a short period of time.
setting
Reference:
This item can be changed if necessary.Specify a position in the model that should be used as the
Detection detection coordinates during measurement.Usually, the central position of the set model is
point registered as the detection coordinates.
Reference:
This item can be changed if necessary.Usually, the central position of the registered region is
Ref. position registered as the reference position.
Reference:
This item specifies the judgement condition for measurement results.Specify the correlation value,
sort condition, and label number.
Measurement Measurement parameter can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
Reference:
This item can be changed if necessary.Normally, the factory default value may be used.
Output
Use the output parameter to specify how to handle the coordinates.
parameter
Reference:

Model Registration (Shape Search+)

Register the parts to measure as the model.
The position at the time of registration is also registered in the model information.Place the
measurement object in the correct position when registering a model.
1.
In the Item Tab area, tap [Model register].
When setting a new model, you do not have to tap [Model register].
FZ3 Processing Items List Manual
Model Registration (Shape Search+) (p.95)
Region Setting (Shape Search+) (p.97)
Detection Point (Shape Search+) (p.97)
Reference Position (Shape Search+) (p.98)
Measurement Parameters (Shape Search+) (p.99)
Output Parameters (Shape Search+) (p.100)
Description
Shape Search+ 95
2