Function Selection (Line Regression)
Functions are selected depending on application.
1.
In the Item Tab area, tap [Select function].
2.
Select a function.
4
Setting item
Select
function
Line 0 (Line Regression)
1.
In the Item Tab area, tap [Line 0].
2.
Set each item in the "Parameter" area.
Setting item
Noise cancel
Method
Number of
points
3.
Tap [OK].
342
Line Regression
Set value
[Factory default]
Calculates a straight line providing the shortest distance from
[Calculate line]
multiple points (Line Regression).
●
Set the Line 0 tab.
Calculate cross
Calculates the intersection and angle between 2 Line
●
point and angle
Regressions.
of two lines
Set the Line 0 tab and Line 1 tab.
Calculate
●
Calculates the distance between a Line Regression and a
distance
point.
between line and
Set the Line 0 and Point tab.
point
Set value
[Factory default]
When a check is placed at [ON], an approximate line is found by
[OFF]
●
excluding the points with large deviation among the measured
ON
●
points.
Nearest unit: Calculated from data of several continuous
coordinate measurement units that were just performed.The
number of units referenced is indicated by the Number of points.
[Nearest unit]
If a unit where coordinate measurement is not performed is
●
Calculation
included in Nearest unit, calculation will not be performed
●
properly and measurement will be NG.
Calculation: Calculated from expression set up.
Reference:
[2] to 8
Set up the number of coordinate points used for calculation.
Description
Description
When Calculation is Selected (p.343)
FZ3 Processing Items List Manual