1.
Select "Figure" for the measurement position and tap Edit.
3
2.
Specify on the image which four points whose information to use for distortion compensation.
3.
Select "Figure" for the reference position and tap Edit.
4.
On the image, specify which information for the positions where the four specified points should
be to use for distortion compensation.
When concrete coordinate positions are known or to measure them and find accurate positions,
it is possible to set "Expression" and substitute measurement values from other processing units.
5.
Place a check at "Filtered image" in the display settings and check the image in which the
distortion has been compensated for.
290
Trapezoidal Correction+
FZ3 Processing Items List Manual