Settings Flow (Label Data)
Set up the label data with the following steps.
List of Label Data Items
Item name
Specify the unit number and label number of the processing unit that is designated as the reference
object.
Setting
In addition, specify the judgement conditions for measurement results.Specify the upper and lower
limit values for the area and the gravity center X/Y.
Reference:
This item can be changed if necessary.Normally, the factory default value will be used.
Output
Use the output parameter to specify how to handle the coordinates.
parameter
Reference:
Setting (Label Data)
Specify the unit number and label number of the unit set for labeling reference.In addition, specify the
judgement conditions for measurement results.
After changing a setting, check whether measurement can be done properly by performing an actual
measurement.
1.
In the Item Tab area, tap [Setting].
2.
In the "Label setting" area, specify each item.
Set value
Setting item
[Factory
default]
[None] to
Label unit
9999
Label No.
[0] to 2499
3.
When the setting has been changed, tap [Measurement] in the Detail area to verify whether
FZ3 Processing Items List Manual
Setting (Label Data) (p.187)
Output Parameters (Label Data) (p.188)
Specify the number of the unit for which the reference object
processing item has been set up.As an option, display the number of
the unit for which the following processing items have been set up.
Labeling
●
Specify the number of the label for the reference object.
Description
Description
Label Data
187
2