Table of Contents
Advertisement
Item
Pattern
select
1
Turn
Brightness
at each part
MG-WAVE or electronic flash controller (FZ-LTA100) is connected:
Electronic flash controller FZ-LTA200 is connected:
CH0 to CH7 are used:
Item
Pattern
select
Brightness at
each part
Other cameras are used:
20
Camera Image Input
Setting
value
Pattern 0 to
Can be selected from a preset lighting pattern.
16
After the camera is installed, if the orientation of the camera does not
match the orientation of the lighting parts, tap [Turn] under the lighting
-
diagram. The lighting diagram rotates 90 degrees clockwise each time
you tap [Turn].
0 to 255 x 8
The light volume at each part can be adjusted to one of 256 levels. 0
ch
indicates the lighting is OFF. The larger the number, the higher the
[0]
brightness.
CH0 to CH3 are used:
Setting
value
Pattern 0 to
Can be selected from a preset lighting pattern.
2
0 to 255
The light volume can be adjusted to one of 256 levels. 0 indicates the
[0]
lighting is OFF. The larger the number, the higher the brightness.
Description
CH4 to CH7 are used:
Description
FZ3 Processing Items List Manual
Advertisement
Table of Contents
