Table of Contents
Advertisement
2
List of Flexible Search Items
Item name
Model
register
Region
setting
Measurement
Output
parameter
Model Registration (Flexible Search)
Register the parts to measure as the model.
A total of 5 models, 0 through 4, can be registered, with no restriction on the size.
If a model has different printing qualities and shapes, more than one models should be registered.
The position at the time of registration is also registered in the model information.Place the
measurement object in the correct position when registering a model.
1.
In the Item Tab area, tap [Model register].
2.
In the "Setting model" area, select a model and tap [New].
54
Flexible Search
This item registers the pattern characteristic of the measurement image as a model.
Model parameter values can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
Reference:
Model Registration (Flexible Search) (p.54)
This item is used to set up the measurement area.
Instead of measuring the entire input image, narrowing the measurement area shortens the
processing time.
Reference:
Region Setting (Flexible Search) (p.57)
This item specifies the judgement condition for measurement results.Specify the criteria to judge the
measurement result if the X and Y coordinates and the correlation with the model are OK.
Reference:
Measurement Parameters (Flexible Search) (p.57)
This item can be changed if necessary.Normally, the factory default value will be used.
Use the output parameter to specify how to handle the coordinates.
Reference:
Output Parameters (Flexible Search) (p.59)
Description
FZ3 Processing Items List Manual
Advertisement
Table of Contents
