Table of Contents
Advertisement
Note
Model Status and Measurement Processing
Measurement time and accuracy may be affected by the status of model in the following ways. Please
●
select measurement objects that are in good condition (clean) for Model Registration.
In the case of large or complicated models, processing time is prolonged.
●
With extremely small models or models without features, search processing is unstable.
●
5.
To register two or more models, repeat the Steps Reference: 2(p.106) to Reference: 4(p.106) .
Note
When a model is registered, the central coordinates of the model are registered as the detection point.A
●
detection point is a point output as a measurement value.If multiple figures are combined, the central
coordinates of the circumscribed rectangle are registered.
Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to
increase the processing speed.Normally, the factory default value will be used.
After changing a setting, re-register the model.
1.
In the "Model parameter" area, select the search mode, then specify a value for each item for
FZ3 Processing Items List Manual
Classification
107
2
Advertisement
Table of Contents
