Table of Contents
Advertisement
1.
In the Item Tab area, tap [Measurement].
2.
In the "Inspection condition" area, specify a value for each item.
Setting item
Inspection mode
Direction
Horizontal succession
Vertical succession
Dictionary candidate
Rough
candidate
Detail
candidate
FZ3 Processing Items List Manual
Set value
[Factory default]
Select the inspection mode of characters.
OCR: The character string is read in.
●
[OCR]
OCR + Count: The character string is read
●
●
OCR + Count
in.Also, the number of characters is inspected.
●
OCV
OCV: Inspects whether or not the same
●
●
characters are lined up as the preset correct
character string combination.
[
]
Specify the direction of character reading.
If the characters are too close together to read in
well, increase this.Specify the allowable
[0] to 99
overlapping range to be read for candidate points.
This item is enabled when "Direction" is "
".
Specify the allowable overlapping range to be
[0] to 99
read for candidate points.This item is enabled
when "Direction" is "
[Unchecked]
●
(Not used)
Specify whether to use candidate point levels
Checked
specified in the Model Dictionary or not.
●
(Used)
0 to 100
When "Dictionary candidate" is unchecked,
[40]
specify a value for the Rough candidate.
0 to 100
When "Dictionary candidate" is unchecked,
[60]
specify a value for the Detailed candidate.
Description
" or "
" or "
".
Character Inspection
2
239
Advertisement
Table of Contents
