Output Parameters (Ecm Search) - Omron XPECTIA FZ3 User Manual

measurements can be made correctly.
4.
Set up the judgement condition.
Note
The values beside each item are measurement results of the displayed image.Take these values into
●
consideration to determine the upper and lower limits.
Setting item
-99999.9999 to
Measure pos X
99999.9999
-99999.9999 to
Measure pos Y
99999.9999
Measure angle -180 to 180
Correlation
0 to 100
[Note 1]
[Note 1]: When the ECM correlation value of the measurement result is 0, the judgement result
will be NG regardless of the measurement parameters setting.

Output Parameters (ECM Search)

Specify how to treat the coordinates to be output to the external device as measurement results.This
item can be changed if necessary.Normally, the factory default value will be used.
Important
After setting up the measurement parameters, changing the output parameters will cause measurement results
●
to vary accordingly.If the output parameters have been changed, re-specify the measurement, too.
1.
Tap [Output parameter] in the Item Tab area.
FZ3 Processing Items List Manual
Set value
Specify the range of X-axis shifting that is judged to be OK.
Specify the range of Y-axis shifting that is judged to be OK.
Specify the range of angles that are judged to be OK.
Specify the range of correlation values that are judged to be
OK.
Description
ECM Search
2
81