Table of Contents
Advertisement
2
5.
To register a color in the region as a reference color, place a check at "Auto update reference
color".
Note
When a check is placed at "Auto update reference color", the average color within the region is
●
automatically registered as the reference color when the region is registered.Each time the region is
updated, the reference color is updated.
To hold the reference color constant, uncheck this option and register the reference color with the
measurement parameters.
Reference:
Measurement Parameters (Color Data)
Set the reference color and judgement conditions.
For Color Cameras:
1.
In the Item Tab area, tap [Measurement].
2.
If necessary, check the "Normalization" option in the "Correction condition" area.
Normally, the factory default value will be used.After changing a setting, check whether
measurement can be done properly by performing an actual measurement.
Setting item
Normalization
156
Color Data
Measurement Parameters (Color Data) (p.156)
Set value
[factory default]
Specify whether to normalize the brightness in calculating the
Checked
color difference.
●
[Unchecked]
When checked, the result is not affected by the total brightness
●
and only the color tone can be detected.
Description
FZ3 Processing Items List Manual
Advertisement
Table of Contents
