Region Setting (2D Code+); Measurement Parameters (2D Code+) - Omron XPECTIA FZ3 User Manual

List of 2D Code+ Items
Item name
This item is used to set up the measurement area.
Region
Restricting the measurement area can shorten the processing time.
setting
Reference:
This item specifies the judgement condition for measurement results.Set the code type and the
Measurement number of characters to be judged as OK.
Reference:
Results Set the measurement results.Judgement results can be classified.
settings Reference:
Output This item can be changed if necessary.Normally, the factory default value will be used.
parameter Reference:

Region Setting (2D Code+)

Specify the rectangular area in which to search for 2D codes.
Restricting the measurement area can shorten the processing time.
1.
In the Item Tab area, tap [Region setting].
2.
Tap [Edit].
The figure setting area is displayed.
3.
Specify the area in which to search for 2D codes.
The rectangle covering the entire screen is set. Adjust the size and position of the rectangle.
4.
Tap [OK].
The area to measure is registered.
Important
Set the region such that the number of pixels in the measurement region is 1920000 pixels or less.
●
Set the measurement region such that it contains only 1 2D Codes.
●
If there is more than one 2D Codes in the measurement region, measurement may not be performed correctly.

Measurement Parameters (2D Code+)

1.
In the Item Tab area, tap [Measurement].
2.
In the standard setting area, set the Code type.
FZ3 Processing Items List Manual
Region Setting (2D Code+) (p.269)
Measurement Parameters (2D Code+) (p.269)
Results Settings (2D Code+) (p.271)
Output Parameters (2D Code+) (p.271)
Description
2D Code+ 269
2