Table of Contents
Advertisement
Setting item
Reference position
Measurement position
Pattern 1:
When the camera is installed tilted and there is no chatter in the work
Reference:
See the setting example (p.289) for when there is no chatter in the work
●
Pattern 2:
When the camera is installed vertical and there is chatter in the work
Reference:
See the setting example (p.291) for when there is chatter in the work.
●
Setting Example for when There Is No Chatter in the Work
Even when there is a mechanical structure and the camera cannot be installed from the front, 4-point
position information can be used to compensate for distortion in the image.
When you specify the four points used for distortion compensation and specify the positions where those
four points should be as reference positions, the parameters for distortion compensation are set
automatically.Each time a measurement is made, the distortion is automatically compensated for using
these parameters.
FZ3 Processing Items List Manual
Pattern 1
Camera: Fixed tilt
Work: No chatter
Figure
Figure
Pattern 2
Camera: Fixed vertical
Work: Chatter
Figure
Expression
Trapezoidal Correction+
3
289
Advertisement
Table of Contents
