Table of Contents
Advertisement
Setting item
Edge level
2
Edge color
level
For monochrome cameras:
Important
Up to 1000 edges can be measured, but only a maximum of 256 can be displayed on the screen.
●
Setting item
Color to
count
Mode
Edge level
3.
If necessary, set each item in the "Noise removal" area.
128
Edge Pitch
Set value
[factory
default]
Specify a color changing level with which the edge is detected.
When the measurement result is lower than the actual number of
0 to 100
edges, specify a smaller value for the edge level.On the other hand,
[50]
when the measurement result is higher than the actual number of
edges, specify a larger value for the edge level.
Reference:
0 to 442
Set the emphasis level for the edge color specified with [Edge color].
[100]
Set value
[factory
default]
[White]
●
Select an edge color to be measured.
Black
●
[Normal]
●
If the pin width or gap is less than 2 pixels, select precise.
Precise
●
Specify the density change level to be detected as edges.
When the measurement result is lower than the actual number,
specify a smaller value for the edge level (or the minimum level).On
0 to 100
the other hand, when the measurement result is higher than the
[50]
actual number, specify a larger value for the edge level (or the
minimum level).
Reference:
Description
See "User's Manual", "Edge level" (p.304)
Description
See "User's Manual", "Edge level" (p.304)
FZ3 Processing Items List Manual
Advertisement
Table of Contents
