Stability
Preciseness
Measurement Parameters (Model Dictionary)
This item can be changed if necessary.Normally, the factory default value will be used.
1.
In the Item Tab area, tap [Measurement].
2.
In the "Measurement condition" area, specify a value for each item.
Set value
Setting item
[Factory default]
Batch
[Checked]
●
setting
Unchecked
●
0 to 100
Correlation
[60]
Rough
0 to 100
candidate
[40]
FZ3 Processing Items List Manual
Specify which is to have priority, detection stability
or speed.
1 to 15
If lowering stability does not speed up processing,
[13]
it is likely that many candidates have been
detected.In this case, specify a larger value for
"Candidate level" or "Stab."
1 to 3
Specify which is to have priority, measurement
[2]
positional precision or speed.
Specify whether to set all Measurement values at the same
time.
Checked: The same contents are set for all indexes.
●
Unchecked: The contents are only set for the selected
●
index.
Specify the lower limit of correlation values that are judged to be
OK. This is the threshold for whether or not the candidate can
be read in as a character.
Specify the threshold value with which to detect candidate
points in a rough search.Specify a smaller value when model
search results are unstable.
Description
Model Dictionary
2
257