Table of Contents
Advertisement
Mask any unnecessary items.
Model
Lower the edge level.
register
Register the error model.
Model
If the measurement results are unstable only when "Rotation" is selected, specify a smaller value
parameter
for the "Skipping angle".
When the processing speed is slow
Parameter to
be adjusted
Region
Make the search region as small as possible.
setting
If images that should be judged OK vary little, specify a larger value for "Candidate level".
Model
When "Rotation" is selected and the model image is a simple figure, specify a larger value for
parameter
"Skipping angle".
Specify a smaller value of the "Reduction".
Specify a larger value of the "Model skipping".
Measurement
Specify a larger value of the "Search skipping".
When Using Measurement Results Externally (ECM Search)
The following values can be output using processing items related to results output.It is also possible to
reference measurement values from expressions and other processing units.
Measurement items
Judgement
Correlation value
Measure X
Measure Y
Measurement angle
Measurement
magnification MX
Measurement
magnification MY
Reference coordinate X
Reference coordinate Y
Reference angle
Detection point RX
Detection point RY
FZ3 Processing Items List Manual
Character
string
JG
Judgement result
CR
Correlation with the model
X
X coordinate of the position where the model is detected
Y
Y coordinate of the position where the model is detected
TH
Angle of the position where the model is detected
MX
X-axis magnification of the detected model
MY
Y-axis magnification of the detected model
SX
X coordinate of the reference position of the registered model
SY
Y coordinate of the reference position of the registered model
ST
Angle of the registered model
RX
X coordinate of the registered model
RY
Y coordinate of the registered model
Remedy
Description
ECM Search
83
2
Advertisement
Table of Contents
