Region Setting (Circle Angle)
This item is used to set up the measurement area.This item specifies the measurement region for [Circle
Angle] with a circle. Ellipses cannot be set.If measurement results are unstable, change detection
conditions as needed.
Note
When drawing the measurement region, the featured part should lie on the circumference.
●
1.
In the Item Tab area, tap [Region setting].
2.
Use the Drawing tools to specify the measurement region.
3.
In the figure setting area, tap [OK].
The measurement region is registered and displayed in the Image Display area.
4.
If necessary, set a value for each item in the "Measurement condition" area.
After changing a setting, check whether measurement can be done properly by performing an
actual measurement.
FZ3 Processing Items List Manual
Circle Angle
277
2