Table of Contents
Advertisement
Note
Specify [Boundary inspection] in [Model register] and [Inspection] in [Measurement] according to the inspection
●
objectives.
Model Registration (Fine Matching)
Register a fine image as the model.By matching this model with input images, unmatched parts will be
detected as defects during inspection.
Note
Ranges that can be registered as models
The two pixels on the edge of the screen are not registered as a model.
●
The registering range will be lower if the images of measurement object are set with Filtering.When you set the image
●
reading range using a camera with the partial scanning function, the range is also limited. Reference:
When figures are drawn overlapping, the settings for objects set up afterward are enabled.
●
Reference:
See "User's Manual", " Setting Figures " (p.319)
1.
In the Item Tab area, tap [Model register].
When setting a new model, you do not have to tap [Model register].
2.
Use the drawing tools to specify the model registration range.
3.
In the figure setting area, tap [OK].
The model is registered.
Changing Model Parameters
The range can be changed as needed to address unstable measurement results.Normally, the factory
default value will be used.
After changing a setting, check whether measurement can be done properly by performing an actual
FZ3 Processing Items List Manual
Filtering (p.294)
Fine Matching
227
2
Advertisement
Table of Contents
