Tools And Parts Required To Remove Components From An Mx2010 Router - Juniper MX2010 Hardware Manual

Table 94: Tools and Parts Required for Component Replacement (continued)
Components
SFB
Serial cable to Auxiliary or Console
Routing Engine port
PSM air filter
Card-cage air filter
Air filter (lower)
RELATED DOCUMENTATION
MX2010 Field-Replaceable Units | 17
Replacing the MX2010 Craft Interface | 468
Replacing an MX2010 Fan Tray | 508
Replacing the MX2010 Air Filters | 449

Tools and Parts Required to Remove Components from an MX2010 Router

To remove components from the router or the router from a rack, you need the following tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
EMI (electromagnetic interference) covers—shipped with router
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Pallet jack with attachment—recommended
Tool or Part
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic discharge (ESD) grounding wrist strap
Blank panels (if component is not reinstalled)
Flat-blade (–) screwdriver
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
432