Tools And Parts Required To Remove Components From An Mx2020 Router; Packing The Mx2020 Router For Shipment - Juniper MX2020 Hardware Manual

Related
Documentation

Tools and Parts Required to Remove Components from an MX2020 Router

Related
Documentation

Packing the MX2020 Router for Shipment

Copyright © 2013, Juniper Networks, Inc.
Appendix G: Contacting Customer Support and Returning MX2020 Hardware
Contacting Customer Support on page 409
Guidelines for Packing Router Components for Shipment on page 413
Packing the Packet Transport Switch Components for Shipment
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
EMI (electromagnetic interference) covers—shipped with router
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Pallet jack with attachment—recommended
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters
Packing the MX2020 Router for Shipment on page 411
Contacting Customer Support on page 409
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
On the console or other management device connected to the master CB-RE, enter
2.
CLI operational mode and issue the following command to shut down the router
software. (If two CB-REs are installed, also issue the command on the backup CB-RE.)
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For more information about the command, see the
.
Command Reference
Junos OS System Basics and Services
411