Tools And Parts Required To Remove Components From An M320 Router; Packing The M320 Router For Shipment - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide
Related
Documentation

Tools and Parts Required to Remove Components From an M320 Router

Related
Documentation

Packing the M320 Router for Shipment

308
The support representative validates your request and issues an RMA number for
4.
return of the component.
Pack the component for shipment.
5.
Contacting Customer Support on page 297
Guidelines for Packing Router Components for Shipment
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters
Contacting Customer Support on page 297
M320 Chassis and Interface Alarm Messages on page 285
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
On the console or other management device connected to the master Routing Engine,
3.
enter CLI operational mode and issue the following command to shut down the router
software. (If two Routing Engines are installed, also issue the command on the backup
Routing Engine.)
user@host> request system halt
Copyright © 2015, Juniper Networks, Inc.