Tools And Parts Required To Remove Components From A T640 Router; Packing The T640 Router For Shipment - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide
Related
Documentation

Tools and Parts Required to Remove Components from a T640 Router

Related
Documentation

Packing the T640 Router for Shipment

494
Description of the failure
The support representative validates your request and issues an RMA number for
4.
return of the component.
Pack the component for shipment.
5.
Contacting Customer Support on page 483
Guidelines for Packing Hardware Components for Shipment
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
7/16-in. (11 mm) nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cable
Wire cutters
T640 Router Description on page 3
T640 Chassis Description on page 15
Locating T640 Component Serial Numbers Using the CLI on page 485
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Copyright © 2017, Juniper Networks, Inc.