Tools And Parts Required To Remove Components From An M120 Router; Packing The M120 Router For Shipment - Juniper Networks Hardware Manual

Tools and Parts Required to Remove Components from an M120 Router

Related
Documentation

Packing the M120 Router for Shipment

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
To remove components from the router or the router from a rack, you need the following
tools and parts:
2.5-mm flat-blade (–) screwdriver, for detaching alarm relay terminal block
3/8–in. nut driver
Blank panels to cover empty slots
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic interfaces or cables
Wire cutters
Packing the M120 Router for Shipment on page 265
Displaying M120 Router Components and Serial Numbers on page 257
Contacting Customer Support on page 263
Guidelines for Packing M120 Components for Shipment on page 267
To pack the router for shipment:
Retrieve the shipping crate and packing materials in which the router was originally
1.
shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
On the console or other management device connected to the master Routing Engine,
3.
enter CLI operational mode and issue the following command to shut down the router
software. (If two Routing Engines are installed, also issue the command on the backup
Routing Engine.)
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For more information about the command, see the Junos OS System Basics and Services
Command Reference.
Appendix G: Contacting Customer Support and Returning M120 Hardware
265