Avaya Definity SI Maintenance Manual page 1037

ATM-TRK (Circuit Emulation Service Circuit Pack)
Table 10-102. ATM Board Framer Looparound Test (#1260) — Continued
Error Test
Code Result
1394 ABORT
2000 ABORT
2060 ABORT
2100 ABORT
2500 ABORT
1 FAIL
2 FAIL
555-233-123
Description/Recommendation
ATM-TRK circuit pack out of service
Run ATM Board Reset Test #1256.
Request timed out.
Retry the command up to 3 times at 1-minute intervals.
Packet-bus link has failed.
Retry the command up to 3 times at 1-minute intervals.
If the test continues to abort, run display errors, and perform the
repairs associated with PKT-INT errors.
Could not allocate the necessary system resources to run this
test.
Internal system error
Retry the command up to 3 times at 1-minute intervals.
Test tone not detected over the looparound; packet-path test
aborted.
Test the active tone clock on the port network, and verify that a
tone is reaching the ATM-TRK circuit pack. If not, correct the
condition.
Run test board UUCSS long.
If the test continues to fail, replace the ATM-TRK circuit pack or
transceiver.
Rerun test board UUCSS long.
TN1655 Packet Interface circuit pack could not detect the correct
data packet.
Test the TN1655 Packet Interface circuit pack to verify that it is
functioning properly. If not, correct the condition.
Run display errors, and perform the repairs associated with DS1
CONV-BD errors, if applicable.
Run display alarms, and perform the repairs associated with
DS1 CONV-BD alarms, if applicable.
Run test board UUCSS long.
If this test continues to fail, replace the ATM-TRK circuit pack.
Run test board UUCSS long.
Continued on next page
Issue 4 May 2002 10-251