Avaya Definity SI Maintenance Manual page 1466

Maintenance Object Repair Procedures
Table 10-248. TEST #1213 Far CSU Loopback Test
Error
Code Result
ABORT
1005 ABORT
1015 ABORT
1039 ABORT
1950 ABORT
ABORT
2100 ABORT
10-680 Issue 4 May 2002
Test
Internal system error
1. Retry test ds1-loop UUCSS far-csu-loopback-test-begin at
1-minute intervals a maximum of 5 times.
Far CSU Loopback Test cannot be executed in the current
configuration. To run this, the TN767E or later suffix DS1 must be
administered for 24-channel operation. The "Bit Rate" field on the
DS1 circuit pack administration form must be set to "1.544" for
24-channel operation.
Ports on the DS1 Interface circuit pack have not been busied out
to out-of-service.
1. Enter the busyout board UUCSS command to put all trunks
or ports of the DS1 Interface circuit pack into the
out-of-service state.
2. Retry the command.
The DS1 Interface circuit pack is providing timing for the system.
Executing this test could cause major system disruption.
If the DS1 Interface circuit pack needs to be tested, set the
synchronization reference to another DS1 Interface circuit pack or
to the Tone-Clock circuit pack via the following command
sequence:
1. Issue the disable synchronization-switch command.
2. Next, issue the set synchronization UUCSS command.
3. Lastly, issue the enable synchronization-switch command.
Another loopback/span test is already executing on the DS1
board or the board is in a network requested loopback mode (Line
loopback or Payload loopback). The hardware error log will
indicate whether a Customer Loopback Jack Test, Far CSU
Loopback Test, or the One-Way Span Test is executing or if the
board is in line loopback or payload loopback mode. Only one
long-duration loopback/span test can be active at a given time.
Thus, if a loopback/span test is already active, that test must be
terminated via the test ds1-loop UUCSS end-loopback/span-test
command in order to execute this test.
Internal system error
Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
Description/Recommendation
Continued on next page
555-233-123