Avaya Definity SI Maintenance Manual page 1535

ETH-PT (Control LAN Ethernet)
Table 10-282. TEST #1282 Link Integrity Inquiry Test — Continued
Error
Code
2500 ABORT
FAIL
PASS
Session Status Test (#1286)
This non-destructive test determines the status of all Ethernet port sessions. This
test queries the system software on port session status.
If the system software indicates that:
All port sessions are up (ALL UP)
Some port sessions are up (SOME UP)
All port sessions are down (ALL DOWN)
555-233-123
Test
Result
Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
Link integrity lost due to problem with attachment of Ethernet
cable to the port.
1. Repeat the test.
2. If the test fails, verify that the cable properly is secured to
Ethernet port and to the bus.
3. Verify the CLAN circuit pack link integrity LED is glowing.
4. Retry the test.
5. If problem persists, refer to Ethernet Local Looparound Test
(#1278) repair procedures.
The Ethernet Link Integrity Test (#1282) detects good
connections.
Description/Recommendation
Continued on next page
Then the switch:
Raises no alarm, or retires alarm
Raises WARNING alarm
Raises MINOR alarm
Issue 4 May 2002 10-749