Avaya Definity SI Maintenance Manual page 870

Maintenance Object Repair Procedures
Table 10-30. TEST #161 Loop Around Test — Continued
Error
Code
0
10-84 Issue 4 May 2002
Test
Result
FAIL The reflective loop around test failed. This could cause noisy
or unreliable connections, or users calling this port may hear
an echo. The problem can also be off-board, as described
below.
1. Since the test may be affected by a line seizure, repeat the
test at 1-minute intervals for a maximum of 5 times.
2. Run circuit pack tests to check the tone generator circuit
pack and the tone detector circuit pack by using the test
board PCSS short command.
3. Resolve any problems that are detected on the tone
generator circuit pack or the tone detector circuit pack.
4. If the tone generator and tone detector circuit packs are
functioning properly and the test still fails and a voice
terminal is connected and wired properly, replace the
analog line circuit pack.
PASS The port is able to provide an analog transmission path to the
station equipment. User-reported troubles on this port should
be investigated by using other port tests, by examining station
wiring, or by examining the station.
NO The test could not relate the internal ID to the port (no board).
BOARD This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use the list config command, and resolve any problems
that are found.
2. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should
re-establish the linkage between the internal ID and the
port. If this is not the case, dispatch to check to ensure
that there is a valid board inserted.
Description/Recommendation
Continued on next page
555-233-123