Avaya Definity SI Maintenance Manual page 1376

Maintenance Object Repair Procedures
Table 10-218. TEST #6 NPE Crosstalk Test — Continued
Error
Code
1004
1020
2000
2100
2053
10-590 Issue 4 May 2002
Test
Result
ABORT The port has been seized by a user for a valid call. Use the
status trunk command to determine when the port is available
for testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, and the port is not in use,
escalate the problem.
ABORT The test did not run due to a previously existing error on the
specific port or a more general circuit pack error.
1. Examine Error Log for existing errors against this port or
the circuit pack and attempt to diagnose the already
existing error.
ABORT Response to the test request was not received within the
allowable time period.
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ABORT At least one of the following errors is found on the DS1 circuit
pack:
1281—Loss of signal
1793—Blue Alarm
2049—Red Alarm
2305—Yellow Alarm
1537—Hyperactivity
Look for the above error types in the Hardware Error Log and
follow the procedures given in the appropriate DS1-BD or
UDS1-BD maintenance documentation for the listed error
types.
FAIL The NPE of the tested port was found to be transmitting in
error. This will cause noisy and unreliable connections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
User-reported troubles on this port should be investigated
using other port tests and examining station, trunk, or external
wiring.
Description/Recommendation
Continued on next page
555-233-123