Avaya Definity SI Maintenance Manual page 648

Maintenance Commands and Trouble-Clearing Aids
maint/idle
maint/entering
maint/testing
maint/
not-refreshed
maint/not-tested
maint/list-config
maint/save~trans
maint/
save~announce
maint/status
maint/patching
maint/periodic
maint/scheduled
maint/analysis
maint/upgrade
Down Modes
down/bad_upgrade
8-398 Issue 4 May 2002
SPE in maintenance mode, but no current maintenance
activity. The active SPE can be either active or selected.
SPE currently restarting the switch software on this SPE.
After the switch software on this SPE finishes its
initialization, the standby SPE is available to perform
maintenance functions.
SPE in maintenance mode executing a test command.
SPE in maintenance mode executing a destructive
background maintenance test that has temporarily left
the standby memory not refreshed. After the current test
finishes, background maintenance refreshes the
standby SPE.
SPE in maintenance mode because previously the
active SPE had been selected with the SPE select
switches. Since the active SPE was not selected, the
standby has not been tested to ensure the standby can
enter standby mode. Once the standby is tested
successfully, the standby returns to standby mode.
SPE in maintenance mode and currently executing a list
configuration command.
SPE in maintenance mode and is currently executing a
save translation command.
SPE in maintenance mode and currently executing a
save announcement command.
SPE in maintenance mode and currently executing a
status card-mem command.
SPE in maintenance mode and currently applying a
software patch to the standby SPE memory.
SPE in maintenance mode and currently performing
periodic background maintenance (performed every two
hours if some component of the standby SPE is
alarmed).
SPE in maintenance mode and currently performing
daily scheduled background maintenance.
SPE in maintenance mode and currently performing
background maintenance testing in response to a
reported trouble by some component in the active or
standby SPE complex that relates to the standby SPE.
SPE in maintenance mode and currently performing a
software upgrade.
2
SPE in down mode (software upgrade attempt failed).
The standby SPE remains in down mode until a
successful software upgrade is performed.
555-233-123