Avaya Definity SI Maintenance Manual page 892

Maintenance Object Repair Procedures
Table 10-35. TEST #47 Loop Around and Conference Test — Continued
Error
Code
0
Station Present Test (also called Ringing
Application Test) (#48)
This test provides a burst of ringing current to the terminal equipment and detects
that current flows. This test is to ascertain whether or not terminal equipment is
connected to the port.
This test may cause some terminal equipment to ring briefly during daily
maintenance. If this ringing is disturbing the customer or the terminal equipment, it
should be disabled using the Tests field of the station administration screen.
However, on some releases of the software, this action disables Tests #6, #47,
and #35 as well as Test #48.
10-106 Issue 4 May 2002
Test
Result
PASS The port is able to provide an analog transmission path to the
station equipment. User-reported troubles on this port should
be investigated by using other port tests, by examining station
wiring, by examining the station, and by ensuring that the
terminal is correctly translated as off-premises or on-premises.
NOTE:
This test always passes for TN712 Analog circuit packs
prior to Vintage 14 and TN742 circuit packs prior to
Vintage 6.
NO The test could not relate the internal ID to the port (no board).
BOARD This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use the list config command, and resolve any problems
that are found.
2. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should
re-establish the linkage between the internal ID and the
port. If this is not the case, dispatch to check to ensure that
there is a valid board inserted.
Description/Recommendation
Continued on next page
555-233-123