Avaya Definity SI Maintenance Manual page 633

status signaling-group
Field descriptions
Group
ID
Type
Group
State
Link
Port
Level 3
State
555-233-123
Numerical ID of the signaling group (1-8)
facility associated signaling
single DS-1 facility. Facility associated signaling groups support only the
simplex D-channel configuration.
non-facility associated signaling
carried by multiple DS-1 facilities.
The DS-1 facility is identified across the ISDN-PRI using an explicit
facility identifier. In a simplex configuration one D-channel is used to
signal for B-channel members, while in a duplex configuration two
D-channels are used to signal for B-channel members (one channel is
active and the other is used as a backup to the active channel).
in-service : one of the D-channels signaling for the group is in
service
out-of-service : neither D-channel in the group is in service
NOTE:
If there is no D-channel backup and the primary D-channel
is out-of-service, then the signaling group is in an
out-of-service state.
Link transporting the D-channel
Address of the port transporting either the primary or secondary
D-channel
State of the primary or secondary D-channels:
in-service : a D-channel is "in-service" when it is in the
multiple-frame-established state at layer 2 carrying normal call-control
signaling at layer 3.
: a D-channel is "standby" when it is in the
standby
multiple-frame-established state at layer 2, and not carrying any layer 3
call-control messages on logical link 0,0.
: a D-channel is in a "wait" state when an attempt has been made
wait
by one side of the interface to establish layer 3 peer communications as
part of the process of going to the "in-service" state, which is transitional
in nature. Only when the ISDN SERVICE
interface, and the far end of the interface responds with a SERVICE
ACKnowledge message is the D-channel placed in the "in-service" state.
: all members are on a
: members can be
message is sent over the
Issue 4 May 2002 8-383