Avaya Definity SI Maintenance Manual page 1533

ETH-PT (Control LAN Ethernet)
Table 10-281. TEST #1281 TCP/IP PING Test — Continued
Error
Code
1003 FAIL
1007 FAIL
PASS
Link Integrity Inquiry Test (#1282)
This non-destructive test queries the CLAN Ethernet port's physical connections.
If:
CLAN connection is present,
CLAN connection is absent,
There is no response,
555-233-123
Test
Result
Ping to the destination failed due to on-board problem.
1. Retry the command at 1-minute intervals, up to 3
times.
2. If the problem persists, reset the circuit pack (busyout
board UUCSS, reset board UUCSS, and release board
UUCSS).
3. If the problem persists, re-administer the ethernet
connection through a different ethernet port, if available.
4. If the problem still persists, or if there are no other available
ethernet ports, replace the circuit pack.
Ping to the destination failed due to the destination down.
1. Verify that at least one destination reachable through this
port is up. Ping this destination (ping ip-address
xxx.xxx.xxx.xxx).
2. If the ping to any destination is successful through this port,
the link is up, although some destinations are unreachable.
Ignore the failure.
3. If ping to all destinations fail, test this port (test port
UUCSSpp short) and follow repair procedures for Session
Status Test (#1286) failures.
TCP/IP Ping Test (#1281) is successful.
Then the test:
Passes.
Fails.
Aborts.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-747