Clsfy-Pt (Call Classifier Port) - Avaya Definity SI Maintenance Manual

Maintenance Object Repair Procedures

CLSFY-PT (Call Classifier Port)

MO Name (in Alarm
Alarm Log) Level
CLSFY-PT(a) MAJOR
CLSFY-PT MINOR
CLSFY-PT WARNING
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier designation (e.g.,
A, B, C, D, or E); SS is the address of the slot in the carrier where the circuit pack is located (e.g.,
01, 02, etc.); and pp is the 2-digit port number (e.g., 01).
The TN744 Call Classifier (CLSFY-BD) circuit pack is a service circuit pack that
enables usage of the Outbound Call Management (OCM) and the Inbound Call
Management (ICM) features. On a G3iV2-386 system, the TN744 also enables
usage of R2-MFC signaling for incoming and outgoing feature operation. There
are eight ports (CLSFY-PTs) on the Call Classifier circuit pack. Each port can
handle call classification, touch-tone reception, or, for G3iV2-386 systems, MFC
tone generation and detection or touch-tone reception.
The CLSFY-PT maintenance feature defines a set of tests to ensure that the Call
Classifier circuit pack ports are capable of detecting tones for call classification,
and detecting and generating necessary tones for correct MFC feature operation.
Hardware Error Log Entries and Test to Clear
Values
Table 10-154. Call Classifier Port (CLSFY-PT) Error Log Entries
Error Aux
Type Data
1 any Tone Detector
Audit/Update Test
(#43)
18 Port has been
busied out by
system technician
257 (b) 17666 Test (#43)
513 (c) any Tone Detection
Verification Test
(#42)
10-412 Issue 4 May 2002
Initial Command to Run
test port PCSSpp sh
test port PCSSpp sh
release port PCSSpp
Alarm
Associated Test Level
MAJOR/
MINOR (a)
WARNING
MAJOR/
MINOR(a)
MAJOR/
MINOR (a)
1
Full Name of MO
Call Classifier Port Maintenance
Call Classifier Port Maintenance
Call Classifier Port Maintenance
On/Off
Board Test to Clear Value
ON test port PCSSpp r 2
OFF release port PCSSpp
ON test port PCSSpp r 3
ON test port PCSSpp r 3
Continued on next page
555-233-123