Avaya Definity SI Maintenance Manual page 1202

Maintenance Object Repair Procedures
Table 10-155. TEST #42 Tone Detection Verification Test — Continued
Error
Code
1-3
101-122
10-416 Issue 4 May 2002
Test
Result
FAIL DTMF digits were not detected correctly. This may or may not
impact reception of R2-MFC calls.
1. Run the short test sequence via the test port PCSSpp sh
r 1 command.
2. If the problem persists, the system is still operating
properly but system capacity will be reduced. In order to
restore system performance to normal, replace the Call
Classifier circuit pack containing the defective CLSFY-PT
(Call Classifier Port).
FAIL Forward or Backward MFC signals were not correctly
generated or detected. This impacts reception of incoming
MFC calls.
1. Run the short test sequence via the test port PCSSpp sh
r 1 command.
2. If the problem persists, the system is still operating
properly but system capacity will be reduced. In order to
restore system performance to normal, replace the Call
Classifier circuit pack containing the defective CLSFY-PT
(Call Classifier Port).
PASS Tone Detection Verification is successful. The Call Classifier
Port (CLSFY-PT) is able to detect/generate all necessary
tones.
Description/Recommendation
Continued on next page
555-233-123