Avaya Definity SI Maintenance Manual page 861

ANL-16-L (16-Port Neon Analog Line)
Station Status and Translation Audits and
Updates Test (#36)
This test updates the Analog port's message lamp state (if it has one) and
translations (such as station type, dial type, network connection) with information
kept in the software. The software is updated with the switchhook state reported
by the port processor. When the ringer is in the off state, this test also turns off the
station's ringer to prevent constant ringing caused by defective hardware.
Table 10-28. TEST #36 Station Status and Translation Audits and Updates Test
Error
Code
1004
1005
1006
555-233-123
Test
Result
ABORT Could not allocate the necessary system resources to run
this test.
1. Retry the command at 1-minute intervals a maximum of
5 times.
ABORT The port was seized by a valid call during the test. The test
has been aborted. Use the display port PCSSpp command
to determine the station extension. Use the status station
command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is
unavailable for certain tests. You must wait until the port is
idle before retesting.
1. Retry the command at 1-minute intervals a maximum of
5 times.
2. If the test continues to abort and the port is not in use,
escalate the problem.
ABORT The test was aborted due to a configuration problem. This
test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the
modem pool member or music on hold).
ABORT This port has been busied out by command, or taken
out-of-service by the failure of the NPE Crosstalk Test.
1. Look in the error log for error type 18 (port busied out) for
this port. If this error is present, release the port with the
release station extension command, and run the test
again.
2. Look in the error log for error type 1025 (NPE crosstalk
test failed) for this port. If this error is present, investigate
the errors associated with the NPE Crosstalk Test 6.
3. Make sure that the terminal is connected and in service,
and then retest.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-75