Avaya Definity SI Maintenance Manual page 1434

Maintenance Object Repair Procedures
Table 10-238. TEST #141 Yellow Alarm Inquiry Test — Continued
Error
Code Test Result
2 FAIL
PASS
0 NO BOARD
10-648 Issue 4 May 2002
Description/Recommendation
The DS1 Interface circuit pack is reporting a yellow F5 State
alarm. There is a fault in the user-network interface from the
user (PBX) to the network.
1. Verify that both endpoints of the DS1 link are
administered using the same signaling mode, framing
mode, and line coding. Likewise, verify that any
intermediate CSUs are administered correctly.
2. If the DS1 interface circuit pack connects to a T1 facility,
call the vendor of the T1 carrier to diagnose the remote
DS1 endpoint. If the DS1 interface circuit pack connects
directly to a switch, call the system technician of the
remote switch to diagnose the DS1 endpoint.
3. Check the physical connectivity of the DS1 pack and of
the cable.
4. If this continues to fail, escalate this problem.
No Yellow alarm nor Remote Multiframe Alarm nor F5 State
Alarm is received from the remote DS1 endpoint.
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is
inserted, an incorrect board is inserted, or an insane board is
inserted.
1. Check to ensure that the board translations are correct.
Use the add ds1 UUCSS command to administer the
DS1 interface if it is not already administered.
2. If board was already administered correctly, check the
error log to determine if the board is hyperactive. If this is
the case, the board is shut down. Reseating the board will
re-initialize the board.
3. If the board was found to be correctly inserted in step 1,
issue the busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID
and the port.
Continued on next page
555-233-123