Avaya Definity SI Maintenance Manual page 824

Maintenance Object Repair Procedures
Table 10-14. TEST #6 NPE Crosstalk Test — Continued
Error
Code
1004
1005
1018
2000
2012
2100
Any
10-38 Issue 4 May 2002
Test
Result
ABORT The port was seized by a valid call during the test. The test
has been aborted.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the
service state of the port. If the port is in use, it is
unavailable for certain tests. Wait until the port is idle
before testing.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
ABORT This condition indicates that the test is not applicable when the
analog port is used in a combined modem pool. This error can
be ignored.
ABORT Test disabled via administration.
1. To enable the test for the particular analog station being
tested, enter the change station <extension> command
and change the "Test?" field on the Station Form from "n"
to "y."
ABORT Response to the test request was not received within the
allowable time period.
ABORT System could not respond to this request.
ABORT Could not allocate the necessary system resources for this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
FAIL The NPE of the tested port was found to be transmitting in
error. This causes noisy and unreliable connections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
User-reported troubles on this port should be investigated by
using other port tests, by examining station wiring, or by
examining the station.
Description/Recommendation
Continued on next page
555-233-123