Avaya Definity SI Maintenance Manual page 1181

CLAN-BD (Control LAN Circuit Pack)
Table 10-145. CLAN-BD Error Log Entries
Error Aux
Type Data
3842 (t)
3844 (u) Any
3845 (v) Any
3846 (w) Any
3848 (x) Any
3849 (y) Any
3850- Any
3861 (z)
3862 (aa) Any
Notes:
a. Error Type 1: Circuit pack stopped functioning or is not physically present.
1. Verify that the circuit pack is present.
2. If circuit pack is present, reset the circuit pack (reset board
3. If the error persists, replace the circuit pack.
b. Error Type 18: The CLAN circuit pack busied out.
c. Error Type 217: applies to 10 circuit packs:
1. Remove the circuit pack(s) against which the error is logged.
d. Error Type 257: Transient communication problem between switch and
circuit pack; does not affect service and can be ignored.
1. Ignore this error, unless the Control Channel Loop Test (#52) fails.
2. If Test #52 fails, replace the circuit pack.
Repetitive failures of the Control Channel Loop Test indicate circuit pack
hardware failure.
e. Error Type 513: Circuit pack detected and reported hardware failure.
1. Reset the circuit pack (reset board UUCSS).
Aux Data:
4352
4353
4355
4356
4357
555-233-123
Alarm
Associated Test Level
UUCSS).
External RAM error
Internal RAM error
ROM Checksum error
Angel Message Corruption error
Instruction set error
On/Off
Board Test to Clear Value
Continued on next page
Issue 4 May 2002 10-395