Avaya Definity SI Maintenance Manual page 1495

DUPINT (Duplication Interface Circuit Pack)
Duplication Interface Circuit Pack Background
Test Query (#271)
This test queries the Duplication Interface circuit pack for the results of its
background tests. The response indicates the results of the last time the following
background tests were run:
ROM Checksum Test: This test verifies the correctness of the Duplication
Interface circuit pack firmware.
RAM Test: This tests verifies that the RAM on the Duplication Interface
circuit pack is functioning properly.
Table 10-261. TEST #271 Duplication Interface Circuit Pack
Error
Code
1000 ABORT
2000 ABORT
2033 ABORT
2008 FAIL
2009
2010
NO
BOARD
555-233-123
Background Test Query Test
Test
Result
System resources required to run this test are not available.
Response to the test request was not received within the
allowable time period.
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5
times.
One or both background tests failed on the Duplication
Interface circuit pack. Error Code 2008 means the ROM test
failed. Error Code 2009 means the RAM test failed. Error Code
2010 means both tests failed.
1. Follow the procedures for replacing Common Control
circuit packs and replace the Duplication Interface circuit
pack.
2. Rerun the test.
The Duplication Interface circuit pack has failed to reply to
handshaking from either the active Maintenance/Tape
Processor (in the case of Duplication Interface circuit pack A) or
from Duplication Interface circuit pack A (in the case of
Duplication Interface circuit pack B).
1. Refer to NO BOARD description for the Duplication
Interface Circuit Pack Status Query Test (#315).
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-709