Avaya Definity SI Maintenance Manual page 1450

Maintenance Object Repair Procedures
Table 10-244. TEST #1209 DS1 Board Loopback Test — Continued
Error
Code Result
1950 ABORT
ABORT
2100 ABORT
10-664 Issue 4 May 2002
Test
Another loopback/span test is already executing on the DS1
board or the board is in a network requested loopback mode
(Line loopback or Payload loopback). The hardware error log will
indicate whether a Customer Loopback Jack Test, Far CSU
Loopback Test, or the One-Way Span Test is executing or if the
board is in line loopback or payload loopback mode. Only one
long-duration loopback/span test can be active at a given time.
Thus, if a loopback/span test is already active, that test must be
terminated via the test ds1-loop UUCSS end-loopback/span-test
command in order to execute this test.
Internal system error
Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of 5
times.
Description/Recommendation
Continued on next page
555-233-123