Avaya Definity SI Maintenance Manual page 1406

Maintenance Object Repair Procedures
w. Error 3902 is used to give status information on a One-Way Span Test. The
value in the Aux Data field indicates the status of the span test.
1
2
3
4
x. Error type 3999 indicates that the circuit pack sent a large number of
control channel messages to the switch within a short period of time. If
error type 1538 is also present, then the circuit pack was taken
out-of-service due to hyperactivity. If error type 1538 is not present, then
the circuit pack has not been taken out-of-service, but it has generated
50% of the messages necessary to be considered hyperactive. This may
be completely normal during heavy traffic periods. However, if this error
type is logged when the circuit pack is being lightly used, it may indicate a
problem with the circuit pack or the equipment attached to it.
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order they are presented in
clearing error codes associated with the NPE Connection Audit Test, for example,
you may also clear errors generated from other tests in the testing sequence
Table 10-230. System Technician-Demanded Tests: DS1-BD
Order of Investigation
NPE Connection Audit Test (#50)
Control Channel Loop Test (#52)
Loss of Signal Alarm Inquiry Test
(#138)
Blue Alarm Inquiry Test (#139)
Red Alarm Inquiry Test (#140)
Yellow Alarm Inquiry Test (#141)
Major Alarm Inquiry Test (#142)
Minor Alarm Inquiry Test (#143)
Slip Alarm Inquiry Test (#144)
Misframe Alarm Inquiry Test (#145)
Translation Update Test (#146)
ICSU Status LEDs Test (#1227)
10-620 Issue 4 May 2002
—
Test is currently running.
—
Test has failed because test could not be activated.
—
Test pattern was not received from the far end.
—
Test has been terminated.
Short Test
Sequence
X
X
X
X
X
X
X
X
X
X
Table
Reset
Long Test Board
Sequence Sequence
X
X
X
X
X
X
X
X
X
X
X
X
Continued on next page
10-230. By
test
ds1-loop D/
1
Command ND
ND
ND
ND
ND
ND
ND
ND
ND
ND
ND
ND
ND
555-233-123