Avaya Definity SI Maintenance Manual page 827

ADX16A-PT (AUDIX Analog Line/Control Link)
Loop Around Test (#161)
This test is designed to check the on-board transmission capabilities of the NPE
on the analog port.
Table 10-16. TEST #161 Loop Around Test
Error
Code Result
ABORT
1000 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
555-233-123
Test
Could not allocate the necessary system resources for this test.
Try (a).
System resources required to run this test are not available. The
port may be busy with a valid call.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the service
state of the port. If the port is in use, wait until it is idle before
testing.
3. When the port is idle, retry the command at 1-minute
intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system
may be under heavy traffic conditions or it may have time slots
out-of-service due to TDM-BUS errors. Refer to "TDM-BUS" to
diagnose TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals a maximum
of 5 times.
The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Resolve any "TTR-LEV" errors.
2. Resolve any "TONE-PT" errors.
3. If neither condition exists, retry the command at 1-minute
intervals a maximum of 5 times.
The port was seized by a valid call during the test. The test has
been aborted.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the service
state of the port. If the port is in use, wait until the port is idle
before testing.
3. When the port is idle, retry the command at 1-minute
intervals a maximum of 5 times.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-41