Avaya Definity SI Maintenance Manual page 926

Maintenance Object Repair Procedures
o. Error type 3999
control channel messages to the switch within a short period of time. If
error type 1538 is also present, then the circuit pack was taken
out-of-service due to hyperactivity. If error type 1538 is not present, then
the circuit pack has not been taken out-of-service, but it has generated
50% of the messages necessary to be considered hyperactive. This may
be completely normal during heavy traffic periods. However, if this error
type is logged when the circuit pack is being lightly used, it may indicate a
problem with the circuit pack or the equipment attached to it.
p. Error Type 2
Data Line extension assigned to the TN750 for uploading and downloading
announcements. The extension can be found by using list data-module.
System Technician-Demanded Tests: Descriptions
and Error Codes
Investigate tests in the order presented in
inspecting errors in the system. By clearing error codes associated with the
Control Channel Loop Around Test, for example, you may also clear errors
generated from other tests in the testing sequence.
Table 10-45. System Technician-Demanded Tests: ANN-BD
Order of Investigation
Control Channel Loop Around Test (#52) (a)
Angel-Speech Processor (SP) Handshake Test
(#208)
Clock Match Inquiry (#212)
Super Frame Match Inquiry (#211)
140AY Loop Around Test (#210)
Announcement Checksum Test (#209)
Network Processor Element (NPE) Audit Test
(#50) (a)
SAKI Test (#53) (a)
1 D = Destructive, ND = Non-destructive
Note:
a. For a complete description of these tests, refer to the "XXX-BD (Common
Port Circuit Pack)" Maintenance documentation.
10-140 Issue 4 May 2002

Indicates that the circuit pack sent a large number of

Check the Class of Restriction (COR) administered for the
Short Test
Sequence
X
X
X
X
Table 10-45 on page 10-140
Reset
Long Test Board
Sequence Sequence
X
X
X
X
X
X
X
Continued on next page
when
D/
1
ND
ND
ND
ND
ND
ND
ND
ND
X D
555-233-123