Power:signals:overshoot - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

24
:POWer Commands

:POWer:SIGNals:OVERshoot

Command Syntax
:POWer:SIGNals:OVERshoot <percent>
<percent> ::= percent of overshoot value in NR1 format
The :POWer:SIGNals:OVERshoot command specifies the percent of
overshoot of the output voltage. This value is used to determine the
settling band value for the transient response and to adjust the vertical
scale of the oscilloscope.
Query Syntax
:POWer:SIGNals:OVERshoot?
The :POWer:SIGNals:OVERshoot query returns the overshoot percent
setting.
Return Format
<percent><NL>
<percent> ::= percent of overshoot value in NR1 format
See Also •
•
•
•
•
•
•
574
(see page 1138)
":POWer:TRANsient:APPLy"
":POWer:SIGNals:AUTosetup"
":POWer:SIGNals:DURation:TRANsient"
":POWer:SIGNals:IEXPected"
":POWer:SIGNals:VSTeady:TRANsient"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:SOURce:VOLTage<i>"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 591
on page 564
on page 572
on page 573
on page 580
on page 581
on page 582