Dot1X Authentication (Interface) - Dell S4810 Reference Manual

Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.4.1.0
Related

dot1x authentication (Interface)

Commands
dot1x authentication (Interface)
Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.
S4810
Syntax
dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.4.1.0
Related dot1x authentication (Configuration)
Commands
dot1x auth-fail-vlan
Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.
S4810
Syntax
dot1x auth-fail-vlan vlan-id [max-attempts number]
Security
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— enables dot1x on an interface.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— enables dot1x globally.
1495