Dell S4810 Reference Manual page 1559

Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The following example configures a community named public that is mapped to
Information the security named guestuser with Read Only (ro) permissions.
The security-name parameter maps the community string to an SNMPv3 user/
security name as defined by the community MIB.
If a community string is configured without a security-name (for example,
snmp-server community public ro), the community is mapped to a default
security-name/group:
•
•
The community-name parameter indexes this command.
If you do not configure the snmp-server community command, you cannot
query SNMP data. Only Standard IPv4 ACL and IPv6 ACL is supported in the
optional access-list-name.
The command options ipv6, security-name, and access-list-name are
recursive. In other words, each option can, in turn, accept any of the three options
as a sub-option, and each of those sub-options can accept any of the three sub-
options as a sub-option, and so forth. The second Example shows the creation of a
standard IPv4 ACL called snmp-ro-acl and then assigning it to the SNMP
community guest.
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
v1v2creadu / v1v2creadg — maps to a community with ro (read-only)
permissions.
v1v2cwriteu/ v1v2cwriteg — maps to a community with rw (read-write)
permissions.
1559