Logging Monitor - Dell S4810 Reference Manual

logging monitor

Specify which messages are logged to Telnet applications.
S4810
Syntax
logging monitor [level]
To disable logging to terminal connections, use the no logging monitor
command.
Parameters
level
Defaults 7 or debugging
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Related
default logging monitor
Commands
setting.
1590
Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 7 or debugging.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— returns the logging monitor parameters to the default
Simple Network Management Protocol (SNMP) and Syslog